Leave Local DNS blank Ok I Figured it out. Navigate to the port forwarding section. Set your computer to a static IP address of Joined May 14, Messages 2, A router in Client Mode is not seen as an access point by laptops or other computers scanning for APs.

Uploader: Mikagami
Date Added: 6 February 2011
File Size: 59.41 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 72541
Price: Free* [*Free Regsitration Required]

Billion G Usernames Billion G Passwords admin admin Enter your username and password in the dialog box that pops up.

If you see this screen, then congratulations, you are now logged in to your Billion G. Change your timezone and DST to match where you are.

Set the wireless network name to exactly the same as your primary router. Leave subnet mask at For a better experience, please enable JavaScript in your browser before proceeding.


Billion 5102G Login Instructions

Leave Local DNS blank Set your computer to a static IP address of While these steps might seem bpac at first, we will walk you through each step for your Billion BipacG router. Billion BipacG routers include a very basic firewall that helps protect your home network form unwanted access from the internet. After entering the IP address of your router you can simply press enter. Your wireless network mode should be set to the same as the primary router. How to Reset the Billion G Router To Default Settings If you still can 5102y get logged in then you are probably going to have to reset your router to its default settings.


Simple Billion Bipac G Router Port Forwarding

You just need one of the 2 wireless routers to have dd-wrt on. Thus, when port forwarding is needed it must be configured at both routers — not just on the main host router. You can use any web browser you like to login to the Billion G. Disable SPI Firewall I dont want to do traffic splitting, all I want to do is extend the wireless network from downstairs to upstairs by connecting the linksys to the telkom, without buying any new hardware.

MidnightWizard Expert Member Dec 12, Now we are going to login to your Billion BipacG router. Go to the wireless, basic settings page and change the wireless mode to Client.

X, you need to set the client router to an IP of A router in Client Mode the client router connects to a main router the host router bipax though it were any other wireless client. Joined May 14, Messages 2, If you are using a broadcom router, read the peacock thread prior to starting.


NAT is used between the routers. Joined Feb 18, Messages 8, Check Assign Wan port to a switch, if you wish to. It looks like this: If you did not see your router’s ip address in the list above. All of the default usernames and passwords for the Billion G are listed below. With that in mind, here is bi;ac to configure it.

How to Login to the Billion G

Perhaps your router’s default password is different than what we have listed here. It is important to setup a static ip address in the device that you are forwarding a port to. If your Internet Service Provider supplied you with your router then you might want to try giving them a call and see if they either know what your router’s username and password are, or maybe they can reset it for you.

Click the Advanced Setup link.

Ok I Figured it out.